Navigation:Home > Product > Tubeless Ready

SHOULD YOU GO TUBELESS CARBON WHEEL?


You can run your Xyz Cycling wheels tubeless. 

However, like any wheelset, there are a few steps you need to follow to successfully install and run a tubeless system.
 
Pros of running tubeless are:

 
More puncture resistant tire system
Ability to run lower PSI
Tire that holds pressure longer (less trips to the pump)
You get to tell all your friends you are running tubeless (if you have ever ridden with anybody who is riding tubeless you already know this)
Cons of running tubeless are:
 
Tires are a lot harder to mount
You usually need an air compressor to get initial inflation
Higher rolling resistance compared to tube/tire system
Changing a flat on the side of the road can be very difficult
Heavier than tire/tube system
Despite the cons, people like the tubeless set up because of the better protection against flat tires. You will be running sealant inside the tire, and with only having a tire to seal (vs. both a tube and tire), small punctures seal themselves. Note that any major cuts, or snake bite flats from bottoming out can still lead to flat tires, even when running tubeless. Yet, for the majority of times where a pinhole type of puncture occurs, tubeless will not flat in those situations.
 
 
 
Things you will need to run a tubeless tire system
 
Tubeless specific tire - The tire MUST say tubeless specific on it. Tubeless specific tires have a reinforced bead on them, if you try to run a non-tubeless specific tire as a tubeless set up it will not seat right and will blow off the rim. 

 
Tubeless valve - In order to create an air tight seal, you need a valve that securely clamps in place. Note that valve extenders do not work with these valves as you have to thread a locking nut on the outside of the valve. If you are running tubeless on a deeper wheel, you will need tubeless valves that are designated for deeper rims.
 
Tubeless rim tape - The standard rim strips that come pre-installed on Xyz Cycling wheels will NOT work for running tubeless. If you are going to run tubeless you will need to remove the pre-installed black rim strips. They are a high pressure nylon strip that just snaps into place, you can simply remove it in one piece (and reuse it later down the road if you would like). For a road setup you will want two layers of the tubeless rim tape on the rim bed.
 
Sealant - The sealant is what helps make the tubeless system more puncture proof. After you have the tire and valve installed, but before inflating the tire, you will want to add the sealant inside the tire.
 
Tire levers - Tubeless tires fit tighter on the rims and can be a lot harder to install. If you are not comfortable using a tire lever then tubeless may not be the best option (especially if you flat while out on a ride). The alloy wheels will be easier to mount a tire on compared to the carbons. With the carbon clinchers, the bead seat is already fairly tight, so installing a tubeless tire on them will be difficult. Use a tire lever, go slowly pushing small part of the tire over the hook. The good news is you don't have to worry about pinching your tube when installing a tire. Note that we have installed dozens of tubeless tires on carbon clinchers and have never had one that was close to being impossible. Some tires go on much easier than others.
 
Air compressor - In order to get initial pressure into the tire and get it to seat in the rim, a pump usually will not supply air fast enough for this. An air compressor can save you a lot of unnecessary pumping (cyclists are notorious for not having arm strength).

ADDRESS

No.45 2nd South Haijing Road,(Bonded Port Area),
Xiamen Area of Pilot Free Trade Zone (Fujian) of China